ELISA Kit for Transgelin (TAGLN)

SMCC; SM22; TAGLN1; WS3-10; Transgelin Variant 2; 22 kDa actin-binding protein; Protein WS3-10; Smooth muscle protein 22-alpha

Specificity

This assay has high sensitivity and excellent specificity for detection of Transgelin (TAGLN).
No significant cross-reactivity or interference between Transgelin (TAGLN) and analogues was observed.

Recovery

Matrices listed below were spiked with certain level of recombinant Transgelin (TAGLN) and the recovery rates were calculated by comparing the measured value to the expected amount of Transgelin (TAGLN) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 84-102 88
EDTA plasma(n=5) 95-105 99
heparin plasma(n=5) 89-101 96

Precision

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Transgelin (TAGLN) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Transgelin (TAGLN) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Transgelin (TAGLN) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 95-105% 83-92% 99-105% 79-89%
EDTA plasma(n=5) 90-104% 99-105% 97-105% 98-105%
heparin plasma(n=5) 81-90% 94-102% 91-102% 80-94%

Stability

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided

Reagents Quantity Reagents Quantity
Pre-coated, ready to use 96-well strip plate 1 Plate sealer for 96 wells 4
Standard 2 Standard Diluent 1×20mL
Detection Reagent A 1×120µL Assay Diluent A 1×12mL
Detection Reagent B 1×120µL Assay Diluent B 1×12mL
TMB Substrate 1×9mL Stop Solution 1×6mL
Wash Buffer (30 × concentrate) 1×20mL Instruction manual 1

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

GIVEAWAYS

INCREMENT SERVICES

Magazine Citations
International Journal of Urology Effects of long-term ketamine administration on rat bladder protein levels: A proteomic investigation using two-dimensional difference gel electrophoresis system PubMed: 23379290
Molecular Medicine Reports  Regulation of angiotensin II-induced B-cell lymphoma-2-associated athanogene 3 expression in vascular smooth muscle cells Pubmed:29484407
Catalog No. Related products for research use of Rattus norvegicus (Rat) Organism species Applications (RESEARCH USE ONLY!)
RPC781Ra01 Recombinant Transgelin (TAGLN) Positive Control; Immunogen; SDS-PAGE; WB.
PAC781Ra01 Polyclonal Antibody to Transgelin (TAGLN) WB; IHC; ICC; IP.
MAC781Ra21 Monoclonal Antibody to Transgelin (TAGLN) WB; IHC; ICC; IP.
SEC781Ra ELISA Kit for Transgelin (TAGLN) Enzyme-linked immunosorbent assay for Antigen Detection.
LMC781Ra Multiplex Assay Kit for Transgelin (TAGLN) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.