ELISA Kit for Delta-Sleep Inducing Peptide (dSIP)

DSIPI; TSC22D3; DIP; GILZ; TSC-22R; hDIP; TSC22 Domain Family Protein 3; Glucocorticoid-Induced Leucine Zipper; Delta Sleep Inducing Peptide,Immunoreactor


This assay has high sensitivity and excellent specificity for detection of Delta-Sleep Inducing Peptide (dSIP).
No significant cross-reactivity or interference between Delta-Sleep Inducing Peptide (dSIP) and analogues was observed.


Matrices listed below were spiked with certain level of recombinant Delta-Sleep Inducing Peptide (dSIP) and the recovery rates were calculated by comparing the measured value to the expected amount of Delta-Sleep Inducing Peptide (dSIP) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 97-105 102
EDTA plasma(n=5) 96-103 101
heparin plasma(n=5) 89-103 99


Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Delta-Sleep Inducing Peptide (dSIP) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Delta-Sleep Inducing Peptide (dSIP) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%


The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Delta-Sleep Inducing Peptide (dSIP) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 87-94% 95-103% 80-94% 78-99%
EDTA plasma(n=5) 86-93% 78-101% 78-90% 95-102%
heparin plasma(n=5) 82-105% 84-98% 95-103% 94-101%


The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided

Reagents Quantity Reagents Quantity
Pre-coated, ready to use 96-well strip plate 1 Plate sealer for 96 wells 4
Standard 2 Standard Diluent 1×20mL
Detection Reagent A 1×120µL Assay Diluent A 1×12mL
Detection Reagent B 1×120µL Assay Diluent B 1×12mL
TMB Substrate 1×9mL Stop Solution 1×6mL
Wash Buffer (30 × concentrate) 1×20mL Instruction manual 1

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 50µL standard or sample to each well.
    And then add 50µL prepared Detection Reagent A immediately.
    Shake and mix. Incubate 1 hour at 37°C;
3. Aspirate and wash 3 times;
4. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
5. Aspirate and wash 5 times;
6. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
7. Add 50µL Stop Solution. Read at 450 nm immediately.



Catalog No. Related products for research use of Homo sapiens (Human) Organism species Applications (RESEARCH USE ONLY!)
RPA708Hu01 Recombinant Delta-Sleep Inducing Peptide (dSIP) Positive Control; Immunogen; SDS-PAGE; WB.
PAA708Hu01 Polyclonal Antibody to Delta-Sleep Inducing Peptide (dSIP) WB; ICC; IHC-P; IHC-F; ELISA.
MAA708Hu22 Monoclonal Antibody to Delta-Sleep Inducing Peptide (dSIP) WB; IHC; ICC; IP.
CEA708Hu ELISA Kit for Delta-Sleep Inducing Peptide (dSIP) Enzyme-linked immunosorbent assay for Antigen Detection.