ELISA Kit for Thymosin Beta 10 (TMSb10)

MIG12; TB10; PTMB10

Specificity

This assay has high sensitivity and excellent specificity for detection of Thymosin Beta 10 (TMSb10).
No significant cross-reactivity or interference between Thymosin Beta 10 (TMSb10) and analogues was observed.

Recovery

Matrices listed below were spiked with certain level of recombinant Thymosin Beta 10 (TMSb10) and the recovery rates were calculated by comparing the measured value to the expected amount of Thymosin Beta 10 (TMSb10) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 97-105 102
EDTA plasma(n=5) 86-99 95
heparin plasma(n=5) 78-93 84

Precision

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Thymosin Beta 10 (TMSb10) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Thymosin Beta 10 (TMSb10) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Thymosin Beta 10 (TMSb10) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 93-102% 84-95% 96-104% 92-105%
EDTA plasma(n=5) 81-92% 90-104% 80-93% 78-102%
heparin plasma(n=5) 87-101% 88-97% 88-104% 85-97%

Stability

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided

Reagents Quantity Reagents Quantity
Pre-coated, ready to use 96-well strip plate 1 Plate sealer for 96 wells 4
Standard 2 Standard Diluent 1×20mL
Detection Reagent A 1×120µL Assay Diluent A 1×12mL
Detection Reagent B 1×120µL Assay Diluent B 1×12mL
TMB Substrate 1×9mL Stop Solution 1×6mL
Wash Buffer (30 × concentrate) 1×20mL Instruction manual 1

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 50µL standard or sample to each well.
    And then add 50µL prepared Detection Reagent A immediately.
    Shake and mix. Incubate 1 hour at 37°C;
3. Aspirate and wash 3 times;
4. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
5. Aspirate and wash 5 times;
6. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
7. Add 50µL Stop Solution. Read at 450 nm immediately.

GIVEAWAYS

INCREMENT SERVICES

Catalog No. Related products for research use of Homo sapiens (Human) Organism species Applications (RESEARCH USE ONLY!)
RPD219Hu01 Recombinant Thymosin Beta 10 (TMSb10) Positive Control; Immunogen; SDS-PAGE; WB.
EPD219Hu61 Eukaryotic Thymosin Beta 10 (TMSb10) Positive Control; Immunogen; SDS-PAGE; WB.
PAD219Hu01 Polyclonal Antibody to Thymosin Beta 10 (TMSb10) WB; IHC; ICC; IP.
MAD219Hu21 Monoclonal Antibody to Thymosin Beta 10 (TMSb10) WB; IHC; ICC; IP.
CED219Hu ELISA Kit for Thymosin Beta 10 (TMSb10) Enzyme-linked immunosorbent assay for Antigen Detection.
LMD219Hu Multiplex Assay Kit for Thymosin Beta 10 (TMSb10) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.