ELISA Kit for Renin (REN)



This assay has high sensitivity and excellent specificity for detection of Renin (REN).
No significant cross-reactivity or interference between Renin (REN) and analogues was observed.


Matrices listed below were spiked with certain level of recombinant Renin (REN) and the recovery rates were calculated by comparing the measured value to the expected amount of Renin (REN) in samples.

MatrixRecovery range (%)Average(%)
EDTA plasma(n=5)81-10197
heparin plasma(n=5)95-103101


Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Renin (REN) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Renin (REN) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%


The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Renin (REN) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

EDTA plasma(n=5)93-105%85-101%90-98%87-94%
heparin plasma(n=5)90-103%90-97%99-105%98-105%


The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided

Pre-coated, ready to use 96-well strip plate1Plate sealer for 96 wells4
Standard2Standard Diluent1×20mL
Detection Reagent A1×120µLAssay Diluent A1×12mL
Detection Reagent B1×120µLAssay Diluent B1×12mL
TMB Substrate1×9mLStop Solution1×6mL
Wash Buffer (30 × concentrate)1×20mLInstruction manual1

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.



The Journal of PhysiologyRecombinant human erythropoietin in humans down-regulates proximal renal tubular reabsorption and causes a fall in glomerular filtration rate Physoc: 194241
The Journal of PhysiologyErythropoietin down‐regulates proximal renal tubular reabsorption and causes a fall in glomerular filtration rate in humansPubMed: 20724370
Kidney InternationalMultiple and large simple renal cysts are associated with prehypertension and hypertension.Pubmed: 23389415
Human PhysiologyEstimation of the parameters of the renin-angiotensin-aldosterone system, water-electrolyte metabolism, and endothelial function in newborns of women with chronic hypertensionSpringer:Source
Gynecological EndocrinologyImmunological and hemostasiological disorders in women with ovarian hyperstimulation syndromePubmed:25200828
PLOS ONEReduced Expression of the Extracellular Calcium-Sensing Receptor (CaSR) Is Associated withActivation of the Renin-Angiotensin System (RAS) to Promote Vascular Remodeling in the Pathogenesis of Essential Hypertension.pubmed:27391973
Catalog No.Related products for research use of Homo sapiens (Human) Organism speciesApplications
RPA889Hu01Recombinant Renin (REN)Positive Control; Immunogen; SDS-PAGE; WB.
PAA889Hu01Polyclonal Antibody to Renin (REN)WB; IHC; ICC; IP.
MAA889Hu22Monoclonal Antibody to Renin (REN)WB; IHC; ICC; IP.
SEA889HuELISA Kit for Renin (REN)Enzyme-linked immunosorbent assay for Antigen Detection.
SCA889HuCLIA Kit for Renin (REN)Chemiluminescent immunoassay for Antigen Detection.