ELISA Kit for Activating Transcription Factor 3 (ATF3)

Cyclic AMP-dependent Transcription Factor ATF3

Specificity

This assay has high sensitivity and excellent specificity for detection of Activating Transcription Factor 3 (ATF3).
No significant cross-reactivity or interference between Activating Transcription Factor 3 (ATF3) and analogues was observed.

Precision

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Activating Transcription Factor 3 (ATF3) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Activating Transcription Factor 3 (ATF3) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Stability

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided

Reagents Quantity Reagents Quantity
Pre-coated, ready to use 96-well strip plate 1 Plate sealer for 96 wells 4
Standard 2 Standard Diluent 1×20mL
Detection Reagent A 1×120µL Assay Diluent A 1×12mL
Detection Reagent B 1×120µL Assay Diluent B 1×12mL
TMB Substrate 1×9mL Stop Solution 1×6mL
Wash Buffer (30 × concentrate) 1×20mL Instruction manual 1

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

GIVEAWAYS

INCREMENT SERVICES

Catalog No. Related products for research use of Mus musculus (Mouse) Organism species Applications (RESEARCH USE ONLY!)
RPC303Mu02 Recombinant Activating Transcription Factor 3 (ATF3) Positive Control; Immunogen; SDS-PAGE; WB.
APC303Mu01 Active Activating Transcription Factor 3 (ATF3) Cell culture; Activity Assays.
RPC303Mu01 Recombinant Activating Transcription Factor 3 (ATF3) Positive Control; Immunogen; SDS-PAGE; WB.
PAC303Mu02 Polyclonal Antibody to Activating Transcription Factor 3 (ATF3) WB; IHC; ICC; IP.
PAC303Mu01 Polyclonal Antibody to Activating Transcription Factor 3 (ATF3) WB; IHC; ICC; IP.
SEC303Mu ELISA Kit for Activating Transcription Factor 3 (ATF3) Enzyme-linked immunosorbent assay for Antigen Detection.
LMC303Mu Multiplex Assay Kit for Activating Transcription Factor 3 (ATF3) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
PGC303Mu01 Primer Pair for Activating Transcription Factor 3 (ATF3) PCR