ELISA Kit for Ribonuclease A7 (RNASE7)

SAP-2; Rnase-A7; Ribonuclease,RNase A Family 7; Skin-derived antimicrobial protein 2

Specificity

This assay has high sensitivity and excellent specificity for detection of Ribonuclease A7 (RNASE7).
No significant cross-reactivity or interference between Ribonuclease A7 (RNASE7) and analogues was observed.

Recovery

Matrices listed below were spiked with certain level of recombinant Ribonuclease A7 (RNASE7) and the recovery rates were calculated by comparing the measured value to the expected amount of Ribonuclease A7 (RNASE7) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 78-99 81
EDTA plasma(n=5) 78-91 83
heparin plasma(n=5) 93-105 101

Precision

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Ribonuclease A7 (RNASE7) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Ribonuclease A7 (RNASE7) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Ribonuclease A7 (RNASE7) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 78-102% 96-103% 90-99% 78-99%
EDTA plasma(n=5) 93-105% 91-99% 83-99% 78-88%
heparin plasma(n=5) 90-97% 81-95% 95-102% 88-96%

Stability

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided

Reagents Quantity Reagents Quantity
Pre-coated, ready to use 96-well strip plate 1 Plate sealer for 96 wells 4
Standard 2 Standard Diluent 1×20mL
Detection Reagent A 1×120µL Assay Diluent A 1×12mL
Detection Reagent B 1×120µL Assay Diluent B 1×12mL
TMB Substrate 1×9mL Stop Solution 1×6mL
Wash Buffer (30 × concentrate) 1×20mL Instruction manual 1

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

GIVEAWAYS

INCREMENT SERVICES

Magazine Citations
International Journal of Molecular Sciences The Human Host Defense Ribonucleases 1, 3 and 7 Are Elevated in Patients with Sepsis after Major Surgery—A Pilot Study Pubmed:26927088
Scientific Reports Measurements of AMPs in stratum corneum of atopic dermatitis and healthy skin–tape stripping technique Pubmed:29374283
Scientific Reports Analysis of the Ribonuclease A superfamily of Antimicrobial peptides in patients Undergoing Chronic peritoneal Dialysis Pubmed: 31123272
Catalog No. Related products for research use of Homo sapiens (Human) Organism species Applications (RESEARCH USE ONLY!)
RPD193Hu01 Recombinant Ribonuclease A7 (RNASE7) Positive Control; Immunogen; SDS-PAGE; WB.
PAD193Hu01 Polyclonal Antibody to Ribonuclease A7 (RNASE7) WB; IHC; ICC; IP.
LAD193Hu71 Biotin-Linked Polyclonal Antibody to Ribonuclease A7 (RNASE7) WB; IHC; ICC.
MAD193Hu21 Monoclonal Antibody to Ribonuclease A7 (RNASE7) WB; IHC; ICC; IP.
SED193Hu ELISA Kit for Ribonuclease A7 (RNASE7) Enzyme-linked immunosorbent assay for Antigen Detection.