ELISA Kit for Serpin A10 (SERPINA10)

PZI; ZPI; Serine(Cysteine)Proteinase Inhibitor,Clade A(Alpha-1 Antiproteinase,Antitrypsin)Member 10; Protein Z-Related Protease Inhibitor; Protein Z Dependent Protease Inhibitor

Specificity

This assay has high sensitivity and excellent specificity for detection of Serpin A10 (SERPINA10).
No significant cross-reactivity or interference between Serpin A10 (SERPINA10) and analogues was observed.

Recovery

Matrices listed below were spiked with certain level of recombinant Serpin A10 (SERPINA10) and the recovery rates were calculated by comparing the measured value to the expected amount of Serpin A10 (SERPINA10) in samples.

Matrix Recovery range (%) Average(%)
sodium citrate plasma(n=5) 84-105 88

Precision

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Serpin A10 (SERPINA10) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Serpin A10 (SERPINA10) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Serpin A10 (SERPINA10) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
sodium citrate plasma(n=5) 93-101% 89-99% 87-101% 95-102%

Stability

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided

Reagents Quantity Reagents Quantity
Pre-coated, ready to use 96-well strip plate 1 Plate sealer for 96 wells 4
Standard 2 Standard Diluent 1×20mL
Detection Reagent A 1×120µL Assay Diluent A 1×12mL
Detection Reagent B 1×120µL Assay Diluent B 1×12mL
TMB Substrate 1×9mL Stop Solution 1×6mL
Wash Buffer (30 × concentrate) 1×20mL Instruction manual 1

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

GIVEAWAYS

INCREMENT SERVICES

Magazine Citations
Thrombosis Research Plasma concentration of protein Z and protein Z-dependent protease inhibitor in patients with haemophilia A PubMed: 23269381
Clin Appl Thromb Hemost Plasma Concentrations of Protein Z and Protein Z-Dependent Protease Inhibitor in Patients With Essential Thrombocythemia PubMed: 25783867
Angiology Assessment of the Procoagulant Activity of Microparticles and the Protein Z System in Patients Undergoing Off-Pump Coronary Artery Bypass Surgery. pubmed:28464697
Catalog No. Related products for research use of Homo sapiens (Human) Organism species Applications (RESEARCH USE ONLY!)
RPC010Hu02 Recombinant Serpin A10 (SERPINA10) Positive Control; Immunogen; SDS-PAGE; WB.
RPC010Hu01 Recombinant Serpin A10 (SERPINA10) Positive Control; Immunogen; SDS-PAGE; WB.
PAC010Hu01 Polyclonal Antibody to Serpin A10 (SERPINA10) WB; IHC; ICC; IP.
MAC010Hu21 Monoclonal Antibody to Serpin A10 (SERPINA10) WB
MAC010Hu23 Monoclonal Antibody to Serpin A10 (SERPINA10) WB; IHC; ICC; IP.
MAC010Hu27 Monoclonal Antibody to Serpin A10 (SERPINA10) WB; IHC; ICC; IP.
MAC010Hu25 Monoclonal Antibody to Serpin A10 (SERPINA10) WB; IHC; ICC; IP.
MAC010Hu29 Monoclonal Antibody to Serpin A10 (SERPINA10) WB; IHC; ICC; IP.
MAC010Hu22 Monoclonal Antibody to Serpin A10 (SERPINA10) WB; IHC
SEC010Hu ELISA Kit for Serpin A10 (SERPINA10) Enzyme-linked immunosorbent assay for Antigen Detection.
LMC010Hu Multiplex Assay Kit for Serpin A10 (SERPINA10) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.