ELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1)

SERPINE1; PLANH1; Serpin Peptidase Inhibitor Clade E Member 1; Nexin,Plasminogen Activator Inhibitor Type 1 Serpin E1; Endothelial plasminogen activator inhibitor

Specificity

This assay has high sensitivity and excellent specificity for detection of Plasminogen Activator Inhibitor 1 (PAI1).
No significant cross-reactivity or interference between Plasminogen Activator Inhibitor 1 (PAI1) and analogues was observed.

Recovery

Matrices listed below were spiked with certain level of recombinant Plasminogen Activator Inhibitor 1 (PAI1) and the recovery rates were calculated by comparing the measured value to the expected amount of Plasminogen Activator Inhibitor 1 (PAI1) in samples.

MatrixRecovery range (%)Average(%)
sodium citrate plasma(n=5)80-10191

Precision

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Plasminogen Activator Inhibitor 1 (PAI1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Plasminogen Activator Inhibitor 1 (PAI1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Plasminogen Activator Inhibitor 1 (PAI1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample1:21:41:81:16
sodium citrate plasma(n=5)91-99%79-90%91-99%90-99%

Stability

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided

ReagentsQuantityReagentsQuantity
Pre-coated, ready to use 96-well strip plate1Plate sealer for 96 wells4
Standard2Standard Diluent1×20mL
Detection Reagent A1×120µLAssay Diluent A1×12mL
Detection Reagent B1×120µLAssay Diluent B1×12mL
TMB Substrate1×9mLStop Solution1×6mL
Wash Buffer (30 × concentrate)1×20mLInstruction manual1

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

GIVEAWAYS

INCREMENT SERVICES

MagazineReference
Clin Appl Thromb Hemost.Is There Any Association Between Thrombosis and Tissue Factor Pathway Inhibitor Levels in Patients With Vitamin D Deficiency?Pubmed: 24203351
Annals of Clinical & Laboratory ScienceAlteration of Hemostatic Parameters in Patients with Different Levels of Subclinical Hypothyroidism and the Effect of L-thyroxine Treatmentpubmed:28249913
Catalog No.Related products for research use of Homo sapiens (Human) Organism speciesApplications
RPA532Hu01Recombinant Plasminogen Activator Inhibitor 1 (PAI1)Positive Control; Immunogen; SDS-PAGE; WB.
PAA532Hu01Polyclonal Antibody to Plasminogen Activator Inhibitor 1 (PAI1)WB; IHC; ICC; IP.
LAA532Hu71Biotin-Linked Polyclonal Antibody to Plasminogen Activator Inhibitor 1 (PAI1)WB; IHC; ICC.
LAA532Hu81FITC-Linked Polyclonal Antibody to Plasminogen Activator Inhibitor 1 (PAI1)WB; IHC; ICC; IF.
MAA532Hu22Monoclonal Antibody to Plasminogen Activator Inhibitor 1 (PAI1)WB; IHC; ICC; IP.
MAA532Hu24Monoclonal Antibody to Plasminogen Activator Inhibitor 1 (PAI1)WB; IHC; ICC; IP.
MAA532Hu21Monoclonal Antibody to Plasminogen Activator Inhibitor 1 (PAI1)WB; IHC; ICC; IP.
MAA532Hu26Monoclonal Antibody to Plasminogen Activator Inhibitor 1 (PAI1)WB; IHC; ICC; IP.
LAA532Hu74Biotin-Linked Monoclonal Antibody to Plasminogen Activator Inhibitor 1 (PAI1)WB; IHC; ICC.
LAA532Hu76Biotin-Linked Monoclonal Antibody to Plasminogen Activator Inhibitor 1 (PAI1)WB; IHC; ICC.
SEA532HuELISA Kit for Plasminogen Activator Inhibitor 1 (PAI1)Enzyme-linked immunosorbent assay for Antigen Detection.
SCA532HuCLIA Kit for Plasminogen Activator Inhibitor 1 (PAI1)Chemiluminescent immunoassay for Antigen Detection.
PSA532Hu01Antibody Pair for Plasminogen Activator Inhibitor 1 (PAI1)ELISA; CLIA; ELISPOT; Luminex; Immunochromatography and other Immunoassays.
KSA532Hu01ELISA Kit DIY Materials for Plasminogen Activator Inhibitor 1 (PAI1)Main materials for "Do It (ELISA Kit) Yourself".