ELISA Kit for Insulin Degrading Enzyme (IDE)

Insulysin; Insulin Protease; Abeta-degrading protease; Insulinase


This assay has high sensitivity and excellent specificity for detection of Insulin Degrading Enzyme (IDE).
No significant cross-reactivity or interference between Insulin Degrading Enzyme (IDE) and analogues was observed.


Matrices listed below were spiked with certain level of recombinant Insulin Degrading Enzyme (IDE) and the recovery rates were calculated by comparing the measured value to the expected amount of Insulin Degrading Enzyme (IDE) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 80-101 93
EDTA plasma(n=5) 85-104 93
heparin plasma(n=5) 97-105 101


Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Insulin Degrading Enzyme (IDE) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Insulin Degrading Enzyme (IDE) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%


The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Insulin Degrading Enzyme (IDE) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 85-93% 98-105% 97-105% 80-93%
EDTA plasma(n=5) 92-99% 97-104% 82-96% 96-105%
heparin plasma(n=5) 85-92% 87-101% 85-98% 78-88%


The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Reagents and materials provided

Reagents Quantity Reagents Quantity
Pre-coated, ready to use 96-well strip plate 1 Plate sealer for 96 wells 4
Standard 2 Standard Diluent 1×20mL
Detection Reagent A 1×120µL Assay Diluent A 1×12mL
Detection Reagent B 1×120µL Assay Diluent B 1×12mL
TMB Substrate 1×9mL Stop Solution 1×6mL
Wash Buffer (30 × concentrate) 1×20mL Instruction manual 1

Assay procedure summary

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.



Magazine Citations
J Neurochem Reduction PubMed: 26442993
African Journal of Pharmacy and Pharmacology Peptide hydroxamate derivatives as regulators for insulin receptor signaling and its degradation by zinc metalloprotease in diabetic rats article-full-text-pdf
Catalog No. Related products for research use of Homo sapiens (Human) Organism species Applications (RESEARCH USE ONLY!)
RPB897Hu01 Recombinant Insulin Degrading Enzyme (IDE) Positive Control; Immunogen; SDS-PAGE; WB.
PAB897Hu01 Polyclonal Antibody to Insulin Degrading Enzyme (IDE) WB; IHC; ICC; IP.
MAB897Hu22 Monoclonal Antibody to Insulin Degrading Enzyme (IDE) WB; IHC; ICC; IP.
SEB897Hu ELISA Kit for Insulin Degrading Enzyme (IDE) Enzyme-linked immunosorbent assay for Antigen Detection.
KSB897Hu01 ELISA Kit DIY Materials for Insulin Degrading Enzyme (IDE) Main materials for "Do It(ELISA Kit) Yourself"